Short answer: germanium held a high plateau through October 2026. The Changjiang Non-ferrous network quoted composite germanium at 28,300 RMB per kilogram and germanium dioxide at 19,800 RMB per kilogram, both unchanged, with germanium ingot of 50 ohm-centimetre resistivity or better at 19,200 RMB per kilogram, up 11.63% from early August and up 48.3% year to date. That ranking puts germanium firmly in the first tier of strategic minor metals. The consequence for anyone holding material is blunt: infrared lens grinding dust, semiconductor wafer sawing sludge and optical fibre preform waste are converted by measured germanium grade, so high-grade clean dust can reach above 10,000 RMB per kilogram while low-grade smelter by-product sludge fetches only a few hundred. If you hold material, assay before you sell. That single step decides more value than any timing call.
This article sets out why germanium is priced the way it is, reproduces the October 2026 quote sheet, gives the grade tiers that determine what scrap is actually worth, describes how germanium dust is refined, and lists what to check before choosing a recycler. Liaocheng Feiyan New Material Technology Co., Ltd. prepared it for customers handling germanium-bearing material.
Germanium has a crustal abundance of roughly seven parts per million and is a classic dispersed metal. There is no independently mineable rich ore. Industrial supply comes almost entirely from two routes: by-product recovery in zinc smelting, and associated recovery from germanium-bearing lignite. Both are hostage to the economics of a different product, which makes germanium output structurally rigid.
Demand sits in three high-barrier sectors, none of which has a cheap substitute:
Locked supply meeting expanding demand is the whole of the fundamental case. A Changjiang Non-ferrous network report of 21 October 2026 put semiconductor-sector germanium demand growth above 30% year on year. Internationally, the International Energy Agency Global Critical Minerals Outlook 2026 lists gallium, magnet rare earths, yttrium, graphite, tungsten, tellurium, cobalt and germanium as the materials at highest supply risk, on the grounds of concentrated supply and limited substitution.
The table reproduces the published quotes. Note that the two germanium figures use different conventions, Changjiang composite spot versus germanium ingot brand export, so the gap between them is normal rather than an error.
| Product | Specification | Price | Unit | Date and source |
|---|---|---|---|---|
| Germanium, composite | National standard metallic germanium | 28,300 (unchanged) | RMB/kg | 2026-10-21 Changjiang Non-ferrous CCMN |
| Germanium dioxide | GeO2 | 19,800 (unchanged) | RMB/kg | 2026-10-21 Changjiang Non-ferrous CCMN |
| Germanium ingot | 50 Ω·cm or better | 19,200 (+11.63% vs early Aug) | RMB/kg | 2026-10-14 Wind / Securities Times |
| Gallium | Ga 99.99% or better | 1,780 (unchanged) | RMB/kg | 2026-10-21 Changjiang Non-ferrous CCMN |
| Indium | Refined indium | 5,380 (unchanged) | RMB/kg | 2026-10-21 Changjiang Non-ferrous CCMN |
| Tellurium | — | 815 (unchanged) | RMB/kg | 2026-10-21 Changjiang Non-ferrous CCMN |
Source: the Changjiang Non-ferrous network (CCMN) spot quotation sheet dated 21 October 2026, Securities Times page A006 of 15 October 2026 citing Wind data, a Changjiang Non-ferrous network report of 21 October 2026 on germanium demand from the semiconductor sector, the International Energy Agency Global Critical Minerals Outlook 2026, and a Guosheng Securities monitoring note of September 2026. As a cross-check, the Shanghai Metal Exchange quoted germanium ingot at a 28,250 RMB per kilogram midpoint on 29 October 2026, unchanged, which is consistent with the Changjiang composite figure. Actual transactions clear at the day's supply and demand.
Secondary germanium does not price off the metal quote directly. The conversion is:
Germanium recovery value = that day's germanium spot benchmark × measured germanium grade of the material − impurity removal and processing loss
Because grade enters as a multiplier, two lots both labelled germanium-bearing scrap can differ in unit value by more than ten times. Sorting by generating process and grade gives the following tiers.
| Scrap category | Typical germanium grade | Indicative recovery value | Pricing note |
|---|---|---|---|
| Infrared lens grinding dust | 20%–85% | Above 10,000 RMB/kg at the clean end | Highest value secondary source; premium for dry, low-abrasive material |
| Semiconductor wafer sawing sludge | 20%–85% | Above 10,000 RMB/kg at the clean end | Value drops sharply with water, coolant and grit content |
| Optical fibre preform and draw waste | Mid grade | Thousands of RMB/kg | Dopant content and cladding separation govern the deduction |
| Lens offcuts and broken blanks | High, known specification | Quoted against measured grade | Retain the original specification label to avoid re-assay |
| Smelter by-product germanium sludge | Low | Hundreds to about 2,000 RMB/kg | High impurity load; treatment loss dominates the price |
Every figure in the value column is indicative and must be confirmed by sampling assay. The spread between the top and bottom rows is the reason no serious buyer quotes germanium scrap from a photograph.
Clean germanium dust and sludge are refined hydrometallurgically, with recovery of 85% to 95% depending on grade and contamination. The practical sequence is drying and de-oiling, oxidative or chlorination leaching to bring germanium into solution, impurity removal and germanium tetrachloride distillation, hydrolysis to germanium dioxide, and finally hydrogen reduction to metal with zone refining where electronic grade is required. Material that arrives dry, separated and labelled moves through this route with a materially higher yield than mixed, wet or oxidised material, which is why packing discipline converts directly into price.
Pack each material form separately and label it. Keep material dry and protected from oxidation in storage and transit. Do not mix germanium-bearing material with other metal scrap: cross-contamination forces the entire lot to be settled at the lowest grade present, and the loss routinely exceeds 30%. For lots above a few hundred kilograms, ask the recycler to sample on site and seal a retained sample jointly, so any later dispute resolves against a physical reference rather than a memory.
Source and disclaimer: the Changjiang Non-ferrous network (CCMN) spot quotation sheet dated 21 October 2026, Securities Times page A006 of 15 October 2026 citing Wind data, a Changjiang Non-ferrous network report of 21 October 2026 on germanium demand from the semiconductor sector, the International Energy Agency Global Critical Minerals Outlook 2026, and a Guosheng Securities monitoring note of September 2026, cross-checked against the Shanghai Metal Exchange germanium ingot quote of 28,250 RMB per kilogram on 29 October 2026. All figures are indicative and dated as shown, and are provided for technical communication. They are not a quotation, not a price commitment and not investment advice. Germanium prices move continuously and actual settlement is governed by mutually accepted assay results and the signed contract. Prepared by Liaocheng Feiyan New Material Technology Co., Ltd..
There is no single price, because germanium scrap is converted by measured grade. As of late October 2026 the Changjiang Non-ferrous network quoted composite germanium at 28,300 RMB per kilogram and germanium dioxide at 19,800 RMB per kilogram, both unchanged, with germanium ingot of 50 ohm-centimetre resistivity or better at 19,200 RMB per kilogram, up 11.63% from early August. On the recycling side, high-grade infrared lens grinding dust and wafer sawing sludge can reach above 10,000 RMB per kilogram, mid-grade optical fibre material runs in the thousands, and low-grade smelter by-product sludge only hundreds to around 2,000 RMB. A sampling assay is the only way to know which one you hold.
Supply cannot respond. Germanium has a crustal abundance of about seven parts per million and is a classic dispersed metal with no independently mineable rich ore, so industrial supply comes almost entirely as a by-product of zinc smelting and from germanium-bearing lignite. Demand meanwhile is concentrated in three high-barrier sectors: infrared optics, where germanium transmits across the full 2 to 14 micron band with a refractive index of 4.0; optical fibre and photonic chips, where germanium tetrachloride dopes the fibre core and high-purity germanium substrates underpin germanium-silicon photonics and AI optical modules; and semiconductors and photovoltaics. A Changjiang Non-ferrous network report of 21 October 2026 put semiconductor-sector germanium demand growth above 30% year on year.
Yes, and it is usually the best material in the building. Grinding dust from infrared lens manufacture and sawing sludge from semiconductor germanium wafers commonly runs 20% to 85% germanium, far richer than primary ore, making it the lowest-cost and highest-grade secondary germanium source available. Hydrometallurgical refining recovers 85% to 95%. Clean, dry dust with little abrasive contamination carries a clear premium over sludge settled out of wastewater, because water, grit and oxide all have to be removed before refining.
Guosheng Securities monitoring in September 2026 put the year-to-date gain in germanium ingot at 48.3%, in line with the first tier of minor metals, and Wind data showed germanium ingot at 19,200 RMB per kilogram on 14 October 2026, up 11.63% from early August. The pattern is a hot thematic market over a stable physical one: policy control keeps supply rigid and infrared plus optical communication demand is well established, so the medium-term price centre is expected to stay high, but the transmission lag between expectation and physical settlement means short-term quotes can disappoint.
It should not be. Mixed loading causes cross-contamination and the whole lot can then only be settled at the lowest-grade category in it, which routinely costs more than 30% of the value. Grinding dust, sludge, lens offcuts and optical fibre waste should be packed separately, assayed separately, and kept dry and protected from oxidation in storage and transit.
State the material form, whether grinding dust, sludge, lens offcuts or optical fibre waste, the approximate quantity, and the region it is in. The recycler then samples and assays on site and quotes against that day's published benchmark. Weighing, assay and payment records should all be available for the transaction, and any material classed as hazardous waste needs its own compliant transfer documentation.
Liaocheng Feiyan New Material Technology Co., Ltd.
Address: Room 8-1503, 15F, Building 9, Xingguang International Financial Center, Dongchang East Road, Dongcheng Sub-district, Liaocheng Economic and Technological Development Area, Shandong, China
Tel: 0635-2112001 / 19963594228 | Email: fykj425@gmail.com
Copyright © Liaocheng Feiyan New Material Technology Co., Ltd.. All Rights Reserved.