Short answer: the Ministry of Commerce has published its 2027 export quota list and silver is not on it - the quota stays suspended and the metal moves to export licence administration. That is a change of instrument, not a removal of control: silver-bearing scrap and recovered silver still have to be cleared shipment by shipment against the current catalogue. For anyone holding silver scrap the practical consequence lands in pricing rather than in logistics, because compliance cost is now explicitly part of the quote, and two lots with the same measured silver content can settle at different recovery factors depending on how complete their origin paperwork is.
The second point is that silver scrap has no single market price. It has a price that is calculated per lot from an assay. This article sets out what the published policy wording actually says, where silver-bearing scrap comes from, the four-step chain that turns an assay into a settlement figure, the recovery routes in use, and the compliance checklist we work to. It closes with the data sources and their dates.
The distinction that matters is between removing a control and changing it. According to the China News Service report of 29 October 2026 on the Ministry of Commerce 2027 export quota announcement, the quota list has been reduced to seven categories: liquorice and liquorice products, ephedra, live pigs, live cattle, live chickens, sawn timber and rush. Phosphate rock and silver continue under suspended quota administration and move to export licence administration. The Strategic Metals Global Review of 30 October 2026 reads the same list as confirming that tungsten, antimony, rare earths, germanium and gallium have all left the quota sequence entirely, with export licences and dual-use item controls as the instruments now in force.
| Item | Status in the 2027 announcement |
|---|---|
| Liquorice and liquorice products, ephedra, live pigs, live cattle, live chickens, sawn timber, rush | Seven categories remain under export quota administration |
| Phosphate rock | Quota administration remains suspended; export licence applies |
| Silver | Quota administration remains suspended; export licence applies |
| Tungsten, antimony, rare earths, germanium, gallium | Left the quota sequence; governed by export licence and dual-use controls |
One gap to be explicit about: the reports we reviewed do not disclose the application procedure, processing time or document list for the silver export licence. We record that as not available and would treat the original Ministry of Commerce announcement in force as the only authoritative source for procedural detail.
The two instruments control different things. A quota controls quantity - the annual volume issued is the volume available. A licence controls the applicant and the end use, applied for and reviewed shipment by shipment. Three consequences follow directly for a silver scrap operator.
Silver scrap is not one material. Measured silver content spans from a few parts per ten thousand to several tens of percent, and the pricing method follows the form rather than the metal. The forms we see most often, and where each one becomes difficult to price:
| Material form | Typical origin | Where pricing gets difficult |
|---|---|---|
| Silver contacts and silver alloy contacts | Low-voltage switchgear, relays, switches | Alloy systems such as silver-cadmium oxide and silver-tin oxide must be assayed for silver separately |
| Silver paste and silver powder | Photovoltaic front-side paste, electronic pastes, conductive adhesives | High organic vehicle content; must be ignited before silver is determined |
| Silver-plated parts | Copper busbar, connectors, lead frames | Thin coating and strong substrate interference; sample representativeness is the controlling issue |
| Silver brazing filler metal | Refrigeration and brazing offcuts | Usually accompanied by copper, zinc and tin; requires multi-element determination |
| Fixer solution and photographic material | Printing plate-making, medical imaging | Liquid must be concentrated first; calculated on volume and concentration together |
| Electronic component offcuts | PCB, thick-film circuits, ceramic capacitors | Mixed material; must be crushed and homogenised before sub-sampling |
There is no standard market price for silver scrap, only a price calculated from the assay result for that particular lot. The chain has four steps, and skipping any one of them is where disputes come from.
At Liaocheng Feiyan New Material Technology Co., Ltd. the precious metal recycling line operates to the flow above. The sampling and assay stages are open to customer witness, and customers in Shandong and elsewhere can send a sample for a reading before a price is agreed. Where silver-bearing material is destined for export, we advise completing the licence check before the goods move, so that shipment and paperwork do not come apart.
Source and disclaimer: the China News Service report of 29 October 2026 on the Ministry of Commerce 2027 export quota announcement, the Strategic Metals Global Review of 30 October 2026, the 100ppi non-ferrous price board of 30 October 2026, the Shanghai Metal Market spot quotation of 30 October 2026 and the CCTV Finance and Xinhua Finance closing reports of 30 October 2026, together with the silver scrap sampling, assay and settlement procedures published by Liaocheng Feiyan New Material Technology Co., Ltd. for its precious metal recycling line. Procedural detail for the silver export licence is recorded as not available and must be taken from the original Ministry of Commerce announcement in force. All figures are indicative and dated as shown, and are provided for technical communication; they are not a quotation, not a price commitment and not legal advice. Prepared by Liaocheng Feiyan New Material Technology Co., Ltd..
No. According to the China News Service report of 29 October 2026 on the Ministry of Commerce 2027 export quota announcement, silver remains under suspended quota administration and moves to export licence administration instead. The control instrument changed from a quota to a licence, so silver-bearing material and recovered silver still have to be applied for shipment by shipment against the current catalogue. The detailed application procedure, processing time and required documents have not been published in the reports we reviewed, and are recorded here as not available; companies should follow the original Ministry of Commerce announcement in force.
Because the settlement price passes through two deductions. The silver scrap settlement price equals the assayed silver content multiplied by the benchmark price and then by a recovery factor, with the refining charge deducted at the end. The recovery factor depends on material form, moisture and impurity content, and lot size. The silver price is only one variable in that calculation, not the final price. A plating bath and a contact strip with the same measured silver content will not settle at the same number.
It depends on what you need to know. XRF suits fast non-destructive screening of coating thickness, but substrate interference is significant. To establish total content you need fire assay or ICP multi-element determination after crushing and sample preparation. For low-content material with several accompanying elements we generally recommend a chemical route rather than relying on a single instrument screen, because the sampling error on a thin coating is usually larger than the instrument error.
Because the organic vehicle in silver paste makes up a high share of the mass. Assaying without igniting first puts the vehicle mass into the denominator and understates the silver content. Removing the organics by ignition and then determining silver is the standard preparation step for paste-type material, and for batch settlement the post-ignition result is the one that should govern.
Four groups. First, proof of origin for the material: purchase contract, invoice, and where hazardous waste classes are involved, the waste transfer manifest. Second, a completed sampling, preparation and assay loop, with the assay report and the settlement sheet filed together. Third, a contract that names the benchmark price convention and how the recovery factor is calculated, which removes most disputes on days when the price moves sharply. Fourth, for material leaving the country, confirmation against the current export licence catalogue for that specific shipment.
Plated parts and paste, for opposite reasons. Plated parts are mispriced because the sample is not representative: the coating is thin and the substrate dominates, so a single spot reading overstates or understates badly. Paste is mispriced when it is assayed without ignition, which understates the content. Mixed electronic offcuts are a third case: they need to be crushed and homogenised before sub-sampling, otherwise the assay describes the handful that was tested rather than the lot that was delivered.
Liaocheng Feiyan New Material Technology Co., Ltd.
Address: Room 8-1503, 15F, Building 9, Xingguang International Financial Center, Dongchang East Road, Dongcheng Sub-district, Liaocheng Economic and Technological Development Area, Shandong, China
Tel: 0635-2112001 / 19963594228 | Email: fykj425@gmail.com
Copyright © Liaocheng Feiyan New Material Technology Co., Ltd.. All Rights Reserved.